banenr

The problem of chicken equipment with deviation manure belt

The quality of the manure belt, the welding of the manure belt, the overlapping rubber roller and the drive roller are not parallel, the cage frame is not straight, etc., Both may cause the scavenging belt to run off

1、Anti-deflector problem: chicken equipment with runaway manure belt may be due to the chicken cage breeding conveyor belt without the installation of the commissioning of the anti-deflector manure belt runaway caused by

2, the quality of the manure belt problems: chicken equipment with the manure belt deviation may be due to the high content of impurities in the manure belt, the composition of the uneven arrangement led to deviation.

3, manure belt welding problems: chicken equipment with runaway manure belt may be due to the connection of the manure belt does not use high-frequency spot welding technology cracking, there is also because the welding is generally manual welding, welding method is also one of the reasons for the chicken equipment manure belt runaway.
pvc_manure_belt_02

For the above several reasons caused by the order, can be solved according to the following solutions

1、For the fault caused by the runaway device: it can be solved by installing the anti-runaway card method. Generally, a set is installed between 6-7 groups of cages, which can prevent the chicken equipment manure belt deviation phenomenon.

2、For the failure caused by the quality of manure belt: can be solved by using polypropylene raw materials without impurities, the use of the process is not easy to stretch deformation method.

3、For the failure caused by the manure belt welding: can be solved by using high-frequency welding, high-frequency welding molding of the rubber strip is semi-circular method. Not easy to crack. Raise the technical department to clear the manure belt on both sides of the length of the connection to re-find the welding, the focus here, is the problem of the joint with, this is the need for welding master skills, generally either poorly welded or incorrectly welded, welding overlap with a variety of ways, should be based on their own welding equipment to choose a reasonable welding method.

4, overlap roller and drive roller is not parallel: adjust the bolt at both ends of the overlap roller, make it parallel.

5、Cage frame is not straight: Re-correct the cage frame.


Post time: Jan-02-2023